I AM NOT RESPONSIBLE FOR ANY DAMAGE CAUSED TO YOUR COMPUTER THROUGH THE USE OF THIS TOOL. You should have received a copy of the GNU General Public License along with this program if not, write to the Free Software Foundation, Inc., 51 Franklin Street, Fifth Floor, Boston, MA 02110-1301, USA. See the GNU General Public License for more details.
This program is distributed in the hope that it will be useful, but WITHOUT ANY WARRANTY without even the implied warranty of MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. This program is free software you can redistribute it and/or modify it under the terms of the GNU General Public License as published by the Free Software Foundation either version 3 of the License, or (at your option) any later version. Previously, the first value would not be displayed until after the last value was gathered, which could result in information as much as 15 seconds out of date on a MacPro. Temperature sensors are now refreshed as soon as the information is available. If they are invalid ( return a negative value, a 0 value or a value above 129 degrees celsius ), marks them as invalid in the registry and rereads keys from registry. Now double checks temperature sensors that are displayed when keys are being read from the registry. Temperature monitor now also monitors current fan speeds.įixes issue where a message would not be display if refresh was delayed.įixes issue where the system could lock up for a few seconds after quitting temperature monitoring and resuming an application that accesses the SMC.
Note: restarting does not reset your fans to default speeds.
In order to upgrade from an earlier version of MacFan that uses an ini file, make sure your fans are spinning at default speeds by putting your computer to sleep or shutting it down before you run the new version of MacFan. All data stored there is now stored in the registry. MacFan 0.65 has been released! Release notes are included below and the changes are summarized here for your convenience: